On the Bench- Making Fibula Safety Pins

IMG_3150 by Stephanie Distler
IMG_3150, a photo by Stephanie Distler on Flickr.
Here are some of the steps involved with making fibula, swirl, safety pins from copper.

I used a 9" piece of 12 gauge copper wire this time bending the spring part first, the swirl next and then the catch. Hammering and adjusting are also involved to make that perfect pin.

This batch is going through the tumbler to provide depth, hardness and a fab shine.

Wubbers pliers, a ball pien hammer, steel block, sandpaper, steelwool and assorted files were used in this project.

Comments

outbound malang said…
may god always give the best to you .. :)